Check CKPS
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect CKPS connector.
- Measure resistance between low signal and high signal terminals of CKPS connector. (Component side)
Specification: 500 ~ 620Ω [20°C (68°F)]
- Is the measured resistance within specification?
YES
- Go to "CHECK SIGNAL WAVEFORM OF CKPS " as follows.
NO
- Substitute with a known - good CKPS and check for proper operation. If the problem is corrected, replace CKPS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.