LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 30 (Engine Control System Diagnosis - 3.3L (5 Of 9)) >> DTC P0335-00: Crankshaft Position Sensor 'A' Circuit >> Wiring Inspection >> Signal Circuit Inspection >> Check open in harness

Check open in harness

WARNING: This page is about a different variant/trim than selected.
  1. IG "OFF". Disconnect CKPS connector and ECM connector.
  2. Measure resistance between low signal terminal of CKPS harness connector and CKPS low signal terminal of ECM harness connector.
  3. Measure resistance between high signal terminal of CKPS harness connector and CKPS high signal terminal of ECM harness connector.

    Specification:  Below 1Ω

  4. Is the measured resistance within specification?

    YES 

    NO 

scientia non olet · About LEMON Manuals