DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible cause |
| DTC Strategy |
- This DTC indicates that a crank shaft reluctor tooth error has not been learned.
|
- Poor connections CKPS
- Condition of the target wheel
- ECM
|
| Enable Conditions |
- Engine load is between 10% and 90%
- Engine speed is between 1500 RPM and 4000 RPM
- TEC (Tooth Error Correction) RPM stability timer is greater than 10 sec.
- Engine Coolant temperature is between 0°C (32°F) and 110°C (230°F)
- Not active disabling faults
|
| Threshold Value |
- Distance driven without learning (during fuel cut off) tooth error is greater than 4000 km (2485 miles)
- Actual Value is higher or lower than calibrated value
|
| Diagnosis Time |
|
| MIL On Condition |
|