Check ECTS resistance

WARNING: This page is about a different variant/trim than selected.

Measure resistance between signal and ground terminals of ECTS connector after checking out the temperature of ECTS with GDS (Component Side)

[Engine Coolant Temperature Sensor]

Temp. (°C)	Resistance (kΩ)	Temp. (°C)	Resistance (kΩ)
-40°C (-40°F)	48.14	40°C (104°F)	1.15
-20°C (-4°F)	14.13 ~ 16.83	60°C (140°F)	0.59
0°C (32°F)	5.79	80°C (176°F)	0.32
20°C (68°F)	2.31 ~ 2.59

Is the measured resistance within specification?
YES
- Clear DTC and Test-drive under the Enable Conditions. After the road test, if this DTC is set, recheck resistance. If not, it is intermittent fault. go to "VERIFICATION OF VEHICLE REPAIR ".
NO
- Substitute with a known - good ECTS and check for proper operation. If the problem is corrected, Go to "Verification of Vehicle Repair" procedure.