Check short to battery in harness
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect ETC Motor & TPS connector and ECM connector.
- Measure resistance between TPS1 signal and TPS power terminals of ETC Motor & TPS harness connector. (Measurement "A")
- Measure resistance between TPS1 signal and ETC motor (+) terminals of ETC Motor & TPS harness connector. (Measurement "B")
- Measure resistance between TPS1 signal and ETC motor (-) terminals of ETC Motor & TPS harness connector. (Measurement "B")
Specification: Infinite
- Is the measured resistance within specification?
YES
- Go to "GROUND CIRCUIT INSPECTION " procedure.
NO
- Repair short to battery in harness. go to "VERIFICATION OF VEHICLE REPAIR " procedure.