Check short to ground in harness
WARNING: This page is about a different variant/trim than selected.
- Turn off the ignition switch. Disconnect TPS and ECM connector.
- Turn on the ignition switch.
- Measure resistance between TPS1 signal terminal of ETC Motor & TPS harness connector and chassis ground. (Measurement "A")
- Measure resistance between TPS1 signal and TPS ground terminals of ETC Motor & TPS harness connector. (Measurement "B")
Specification: Infinite
- Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair the connector. go to "VERIFICATION OF VEHICLE REPAIR " procedure.