LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 29 (Engine Control System Diagnosis - 3.3L (2 Of 9)) >> DTC P0113-00: Intake Air Temperature Sensor 1 Circuit High Input >> Wiring Inspection >> Ground Circuit Inspection >> Check open in harness

Check open in harness

WARNING: This page is about a different variant/trim than selected.
  1. IG "OFF". Disconnect IATS connector and then IG "ON".
  2. Measure voltage between signal terminal of IATS harness connector and chassis ground. (Measurement "A")
  3. Measure voltage between signal and ground terminals of IATS harness connector. (Measurement "B")

    Specification:  Voltage difference between measurement "A" and "B" is below 200 mV.

  4. Is the measured voltage within specification?

    YES 

    • Go to "Component Circuit Inspection" procedure.

    NO 

scientia non olet · About LEMON Manuals