DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy		Plausibility check	Connecting condition Open or short to ground in power circuit Open or short to ground in signal circuit Faulty TPS Faulty MAPS Faulty ECM
Case 1	Enable Condition	Engine speed during engine start is greater than 608 ~ 960 RPM Pressure quotient (MAP/BARO) is less than 0.8 Battery voltage is between 11V and 16V
	Threshold Value	Filtered Reduced Area controller is less than -90% ~ -40% or Filtered Reduced Area controller is greater than +40% ~ 99.5%
	Diagnosis Time	5 seconds
	MIL On Condition	2 Drive Cycles
Case 2	Enable Condition	Engine speed during engine start is greater than 608 ~ 960 RPM Pressure quotient (MAP/BARO) is greater than 0.8 Battery voltage is between 11V and 16V
	Threshold Value	Filtered BARO controller is less than -14.5% ~ -20% or greater than +14% ~ +20%. (Versus BARO)
	Diagnosis Time	5 seconds
	MIL On Condition	2 Drive Cycles
Case 3	Enable Conditions	Engine off time is more than 2.6 seconds Engine speed is less than 32 RPM BARP sensor value is between 400 hPa and 1150 hPa MAP sensor voltage is between 0.2V and 4.8V Pressure Up Throttle (PUT) sensor voltage is between 0.2V and 4.8V
	Threshold Value	Manifold air pressure (MAP) is out of range (engine stopped)
	Diagnosis Time	Immediate
	MIL On Condition	2 Drive Cycles
Case 4	Enable Conditions	Engine speed during engine start is 608 ~ 960 RPM
	Threshold Value	Manifold air pressure (MAP) is out of range (engine running)
	Diagnosis Time	-
	MIL On Condition	-