Check fuel pressure sensor performance
WARNING: This page is about a different variant/trim than selected.
- IG "OFF".
- Engine start.
- Measure the voltage between signal terminal of fuel pressure sensor harness connector and ground.
Specification: Approx. 1.9 ~ 3.2V (in idle)
- Is the measured voltage normal?
YES
- Substitute with a known - good FECM and check for proper operation. If the problem is corrected, replace FECM and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good fuel pressure sensor and check for proper operation. If the problem is corrected, replace fuel pressure sensor and go to "VERIFICATION OF VEHICLE REPAIR " procedure.