DTC Information: DTC Detecting Condition

WARNING: This page is about a different variant/trim than selected.

Item		Detecting Condition	Possible Cause
DTC Strategy		Monitor the fuel rail/system pressure - too high	Jammed injector Mechanical failure in High Pressure Pump Sticking by high pressure of rail pressure sensor
Case 1	Enable Condition	Engine speed is between 512 RPM and 7008 RPM
	Threshold Value	Filtered fuel pressure is greater than 25 mPa
	Diagnosis Time	2 seconds
Case 2	Enable Condition	Engine speed is between 512 RPM and 6816 RPM Mass fuel flow is between 0.012 g/rev and 0.36 g/rev. Time after engine start is greater than 15 seconds Volume of fuel flow is less than 14.5~ 216 (l/h)
	Threshold Value	Delivery of high pressure pump is too high
	Diagnosis Time	8 seconds
Case 3	Enable Conditions	Time after engine start is greater than 2 seconds Volume of fuel flow is less than 14.5~216 (l/h) Mass of fuel flow is greater than 0.012 g/rev. Engine speed is faster than 512 RPM
	Threshold Value	Fuel pressure during catalyst heating is too high
	Diagnosis Time	8 seconds
MIL On Condition		2 Drive Cycles