Open Check
WARNING: This page is about a different variant/trim than selected.
- IG "OFF".
- Disconnect TCM and ECM (ECM) connector.
- Measure resistance between P-CAN HIGH terminal (LOW terminal) of the TCM harness connector and P-CAN HIGH terminal (LOW terminal) of the ECM (ECM) harness connector.
Specification: Approx. below 1Ω
- Is the measured value within specifications?
YES
- Go to "COMPONENT INSPECTION ".
NO
- Repair open in P-CAN BUS line between TCM harness connector and ECM (ECM) harness connector and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.