Check open in CAN BUS line
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect ECM, smart junction box (gateway) connector.
- Check resistance between P-CAN HIGH terminal of ECM Connector and P-CAN HIGH terminal of each module. (Measurement "A")
- Check resistance between P-CAN LOW terminal of ECM Connector and P-CAN LOW terminal of each module. (Measurement "B")
Specification: Below 1.0Ω
- Is the measured resistance within specification?
YES
- Go to "COMPONENT INSPECTION ".
NO
- Repair open in CAN BUS line. go to "VERIFICATION OF VEHICLE REPAIR ".