Resistance Check
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect ECM, smart junction box (gateway) connector.
- Measure the resistance between P-CAN HIGH and P-CAN LOW terminals of ECM (Component side)
- Measure the resistance between P-CAN HIGH and P-CAN LOW terminals of smart junction box (gateway) (Component side)
Specification: Approx. 120Ω
- Is the measured resistance within specification?
YES
- Go to next procedure.
NO
- Replace the module which abnormal resistance is measured, and go to "VERIFICATION OF VEHICLE REPAIR " procedure.