LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2021 >> G90 5.0 Ultimate, RWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 22 (Engine Control System Diagnosis - 3.3L (1 Of 9)) >> DTC P0076-00: Intake Valve Control Solenoid Circuit-Low (Bank 1) >> Component Inspection >> Check OCV resistance

Check OCV resistance

WARNING: This page is about a different variant/trim than selected.
  1. Turn off the ignition switch.
  2. Disconnect OCV and ECM connector.
  3. Measure resistance between power and signal terminals of OCV. (Component Side)

    Specification:  7.0 ~ 8.0 Ω (20°C/68°F)

  4. Is the measured resistance within specification?

    YES 

    • Go to "OCV Actuation Test" as follows.

    NO 

    • Substitute with a known - good OCV and check for proper operation. If the problem is corrected, replace OCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals