RCV Resistance Inspection: Notes
WARNING: This page is about a different variant/trim than selected.
- IG "OFF".
- Disconnect RCV connector.
- Measure resistance between power terminal and control terminal of the sensor connector (Component side)
Specification:
ITEM Resistance (Ω) Normal Parameter At 20°C (68°F) 28.3 ~ 31.1 - Is the measured resistance within specification?
YES
- Go to next step as below.
NO
- Substitute with a known - good RCV and check for proper operation.
If the problem is corrected, replace RCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.