Check RCV resistance
WARNING: This page is about a different variant/trim than selected.
- IG "OFF".
- Disconnect RCV connector.
- Measure resistance between power terminal and control terminal of the sensor connector (Component side)
Specification:
ITEM Normal Parameter At 20°C (68°F) Resistance (Ω) 28.3 ~ 31.1 - Is the measured resistance within specification?
YES
- Check for poor connection between ECM and component: backed out terminal, improper mating, broken locks or poor terminal to wire connection. Repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure
NO
- Substitute with a known - good RCV and check for proper operation. If the problem is corrected, replace RCV and go to "VERIFICATION OF VEHICLE REPAIR " procedure.