CMPS, CKPS Inspection

WARNING: This page is about a different variant/trim than selected.

IG "OFF" and connect GDS.
Engine running. Measure signal waveform at signal terminal of CMPS.
Measure signal waveform at signal terminal of CKPS.
Specification:

17th signal of the CKPS after missing tooth of target wheel is aligned with the high signal of the CMPS at idle, ECM recognizes that Synchronization between CKPS and CMPS is completed.

Refer to SIGNAL WAVEFORM & DATA
Is the measured signal waveform O.K?
YES
- Fault is intermittent. Drive the vehicle to meet the Enable Conditions for the DTC. go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Go to "Timing Mark Inspection" procedure as follow.