DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
- Deviation check between actual CAM position and CAM setpoint position in case of changing setpoint (slow response of actuator)
|
- Poor connection
- Contamination of oil/Clogged oil line
- Faulty oil control valve
- Faulty CAM phaser
- Faulty exhaust CVVT assembly
|
| Enable Conditions |
- Camshaft set-point movement more than 12°CRK within in less than 1s
- Camshaft set-point moved more than 3 times since engine start
- Engine speed at between 450 RPM and 5000 RPM
- Engine oil temperature at between 68°F (20°C) and 248°F (120°C)
- Battery voltage at between 11V and 16V
|
| Threshold Value |
- CAM position movement less than 4°CRK within 1s
|
| Diagnostic Time |
|
| MIL On Condition |
|