Check OTS resistance
WARNING: This page is about a different variant/trim than selected.
- IG "OFF". Disconnect OTS connector.
- Measure resistance between signal and ground terminals of OTS connector (Component Side) after recording the temperature of EOTS with GDS.
Specification:
Temperature (°C/°F) Resistance (kΩ) -40°C (-40°F) 41.74 ~ 54.54 -20°C (-4°F) 14.13 ~ 16.83 0°C (32°F) 5.28 ~ 6.3 25°C (77°F) 1.88 ~ 2.14 80°C (176°F) 0.31 ~ 0.33 140°C (284°F) 0.07 ~ 0.08 - Is the measured resistance within specification?
YES
- go to "VERIFICATION OF VEHICLE REPAIR " procedure.
NO
- Substitute with a known - good OTS and check for proper operation. If the problem is corrected, replace OTS and go to "VERIFICATION OF VEHICLE REPAIR " procedure.