DTC Information: DTC Detecting Condition
WARNING: This page is about a different variant/trim than selected.
| Item |
Detecting Condition |
Possible Cause |
| DTC Strategy |
|
- Clogged air cleaner
- Faulty BPS
|
| Case 1 |
Enable Conditions |
- Engine stops more than 2.6 seconds
- Engine speed is lower than 32 RPM
- Barometric pressure (BARO) sensor voltage is between 0.2V and 4.9V
- Manifold air pressure (MAP) sensor voltage is between 0.2V and 4.8V
- Pressure up throttle (PUT) sensor voltage is between 0.2V and 4.8V
|
| Threshold Value |
- Barometric pressure (BARO) is out of range (engine stopped)
- BARO is 15 kPa greater than MAP
- BARO is 15 kPa greater than PUT
- PUT is 15 kPa lower than PUT
|
| Case 2 |
Enable Conditions |
- Engine speed is faster than 32 RPM
|
| Threshold Value |
- Barometric pressure (BARO) is out of range (engine running)
- BARO (closed throttle) is 15 kPa greater than PUT (closed throttle)
- PUT (full load) is 20 kPa greater than PUT (closed throttle)
- PUT (full load) is -35 ~ 10 kPa greater than BARO (full load)
|
| Diagnosis Time |
|
| MIL On Condition |
|