GDS Data Analysis
WARNING: This page is about a different variant/trim than selected.
- With vehicle raised on a lift, start the engine and place transaxle in Drive. Let vehicle idle and verify speedometer indicates approx. 10 km/h or more (6 mph or more) on the instrument cluster.
- Connect GDS and select ABS/ESP system.
- Monitor the "WHEEL SPD SENSOR-FR" parameter on the current data list.
Specification: 10 km/h or more (6 mph or more)
- Is value within the specification?
YES
- Wheel speed sensor is OK. Go to Go to "Signal Circuit Inspection [With ABS]" procedure.
NO
- Check for open or short circuit between wheel speed sensor (FR) and ABS/ESP control module.
- If problems are found, repair as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.
- If OK, Check wheel speed sensor (FR) as follow:
- Gap between wheel speed sensor and trigger wheel (Air gap: 0.3~1.1 mm (0.011 ~ 0.043 in))
- Trigger wheel condition
- Replace wheel speed sensor as necessary and go to "VERIFICATION OF VEHICLE REPAIR " procedure.