Repair Procedures: Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
NOTE:
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
- Take care not to bend or scratch the trim and panels.
- Open the glove box (A) in the direction of the arrow.
- Separate the air pin (A) from the glove box (B).
- Remove both stoppers (B) from the glove box (A) by turning the stoppers.
- Disconnect the pushpins (A) and then remove the glove box (B).
- To install, reverse the removal procedure.
Information
- Make sure the connector is connected properly.
- Replace any damage clips.