Repair Procedures: Replacement

CAUTION:

NOTE:

When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
When removing the interior trim pieces, use a plastic panel removal tool not to damage the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the crash pad side cover (A).
[LH]

Courtesy of HYUNDAI MOTOR AMERICA

[RH]

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the crash pad center panel assembly [RH](A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the start switch connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the crash pad center garnish assembly [RH](A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the crash pad center panel assembly [LH](A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the crash pad center garnish assembly [LH](A).

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the cluster fascia panel (A).

Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse the removal procedure.
Information
- Replace any damaged clips (or pin-type retainers).
- Make sure the connector is connected properly.
- Press the cluster fascia in the direction of installation (To front of a vehicle) so that self clips are locked completely.
- Check the step height difference after installation.