Description And Operation: Description: Function

High speed CAN communication (C-CAN)
- Custom Function: car seats linked to getting on/off motion Welcome Light
- LKAS: Lane Keeping Assist System
- HUD: Head Up Display System
Low speed CAN communication (M-CAN)
- AV: Audio/Video Multimedia information Display
- TBT: Turn By Turn Navigation Information Display

Various source control

Various alarms and sound effects are issued through the external amplifier of AVN system.

WARNING:

Warning and guide sounds regarding engine start and driving are generated through the external amplifier.
- Hazard lamp, seat belt warning, turn signal, HDA Hand OFF, LKAS, RCTA, etc.
When the external amplifier or speakers are replaced with other products, a failure may occur in the amplifier and warning and guide sounds (excluding the ETCS guide sound) may not be generated.
Virtual engine sound inside the vehicle (occurs in Sport mode) is generated by the external amplifier. Therefore, if the external amplifier or speakers are replaced with other products, a failure may occur in the amplifier and virtual engine sound may not be generated properly.

Sound	Description and Function
Seatbelt Warning	This alarm is generated when you do not wear a seatbelt.
Front Collision Warning	This alarm is generated when there is a risk of collision with the front vehicle.
PAS System Warning	This alarm is generated when the PAS sensor fails.
Gear R	This sound is generated when you shift the lever to the R position.
Electronic Parking Brake	This alarm is generated when the parking brake does not meet the auto deactivation conditions (e.g. door, hood, or trunk open).
Electronic Parking Brake	This alarm is generated when the brake is in the Auto Hold mode and does not meet the auto deactivation conditions.
Door Open Warning	This alarm is generated when you drive the vehicle at 10 km/h or lower with an open door.
Hood Open Warning	This alarm is generated when you drive the vehicle at 10 km/h or lower with the hood open.
Sunroof Open Warning	This alarm is generated when the ignition switches from On to Off with the sunroof open
Smart Key Removed	This alarm is generated when the smart key is removed or when the smart key is disabled.
Welcome	Welcome sound (determined by the cluster)
Goodbye	This goodbye sound is generated with the relevant message when the ignition switches from ON to Off (determined by the cluster).
Turn Signal Lamp (Tick)	This sound is generated when you operate a turn signal lamp.
Turn Signal Lamp (Tock)	This sound is generated when you operate a turn signal lamp.
SBW Warning	This alarm is generated when a warning message is displayed or when you shift the lever to the P position with ignition Off.
Pop-up Warning	This alarm is generated when a pop-up message is displayed due to service alarm, TPMS, SCC, HAD, LKAS, DAA, AEB, BSD, ESC, PSB, HBA, WPC, engine overheat, rheostat brightness, etc.
Voice Message	Depress the brake and start the engine.
	Start the engine at the P or N position.
	You selected the Smart Cruise Control.
	You selected the Cruise Control.
	Depress the brake when you shift the lever.
	Park the car and shift the lever to the P position.
	Replenish the washer fluid.
	The door is open.
	The hood is open.
	The sunroof is open.
	The window is open.
	The door and hood are open.
	Volume 1, Volume 2, Volume 3
	Your mobile phone is on the wireless charger.

User Setting Mode (USM)
Setting can be changed by using switches menu, UP, Down and OK button). There are many items (for example, In/Out Seat Synchronization, In/Out Steering Wheel Synchronization, Auto Door Lock, Auto Door Lock Deactivate, Head Lamp Escort, Welcome Light, Welcome Sound, One Touch Turn Signal, Average Fuel Consumption Auto Reset, Brightness, and Content Setup) that can be set and customized.