Removal and Installation
- Remove the engine room front under cover.
(Refer to Engine and Transmission Assembly - "ENGINE ROOM UNDER COVER ")
- Disconnect the intercooler inlet hose (A).
Tightening torque:
4.9 - 6.9 N.m (0.5 - 0.7 kgf.m, 3.6 - 5.1 lb-ft)
(If equipped with a cap, tighten it until the cap is removed.)
- Remove the intercooler inlet hose & pipe (A).
- Remove the intercooler upper mounting bracket (A).
Tightening torque:
21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)
[LH]
[RH]
- Remove the intercooler (A).
- Remove the intercooler lower mounting bracket (A).
Tightening torque:
21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)
[LH]
[RH]
- Install in the reverse order of removal.