CAN Register and Communication Line Inspection 2
- IG key "OFF".
- EPCU, BMS, A.A.F, FATC...connector.
- Measure resistance between terminal CAN Low and CAN High of PCM.
- Measure resistance between terminal CAN Low and CAN High of BMS.
Specification : About 120 Ω
- Is the measured value within specification?
YES
- Go to next procedure.
NO
- Substitute with a known-good "PCM, BMS" and check for proper operation. If the problem is corrected, replace "PCM, BMS" and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.