Repair Procedures: Replacement
CAUTION:
- Put on gloves to prevent hand injuries.
Information
- When removing with a flat-tip screwdriver or remover, wrap protective tape around the tools to prevent damage to components.
- Use a plastic panel removal tool to remove interior trim pieces without marring the surface.
- Take care not to bend or scratch the trim and panels.
- Remove the glove box.
(Refer to "GLOVE BOX ")
- Using a screwdriver or remover, remove the crash pad side cover [RH] (A).
- After loosening the mounting screws, remove the crash pad center panel [RH] (A).
- After loosening the mounting screws bolts and nuts, remove the glove box housing cover (A).
- Disconnect the glove box lamp connector (A) and lamp switch connector (B).
- To install, reverse the removal procedure.
Information
- Make sure the connector are connected in properly.
- Replace any damaged clips (or pin-type retainers).