Removal And Installation
WARNING: This page is about a different variant/trim than selected.
- Remove the lower oil pan.
(Refer to Lubrication System - "OIL PAN ")
- Remove the upper oil pan.
- Remove the bolt (A) and then separate the chain with sprocket from the oil pump.
Tightening Torque:
19.6 - 24.5 N.m (2.0 - 2.5 kgf.m, 14.5 - 18.1 lb-ft)
- Remove the oil of proportional control solenoid connector (A).
- Remove the oil pump bracket bolt (A).
- After loosening the oil pump mounting bolt, remove the oil pump (A) and upper oil pan together.
Tightening Torque:
20.6 - 22.6 N.m (2.1 - 2.3 kgf.m, 15.2 - 16.6 lb-ft)
- Install in the reverse order of removal.