LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 44 (Lubrication System - 3.3L) >> Oil Pan >> Repair Procedures >> Removal >> [AWD Upper Oil Pan]

[AWD Upper Oil Pan]

WARNING: This page is about a different variant/trim than selected.
  1. Remove the sub frame from the vehicle.
  2. Remove the Driveshaft and axle.

    (Refer to Driveshaft and Axle - "FRONT DRIVESHAFT ")

  3. Remove the Front Differential Carrier.

    (Refer to Driveshaft and Axle - "FRONT DIFFERENTIAL ASSEMBLY (AWD) ")

  4. Remove the Timing chain cover.

    (Refer to Timing System - "TIMING CHAIN COVER ")

  5. Remove the lower oil pan.

    (Refer to Lubrication System - "OIL PAN ")

  6. Remove the air conditioning compressor.

    (Refer to Heating, Ventilation, Air Conditioning - "COMPRESSOR ")

  7. Remove the adjustable oil pump connector, and after retaining clips (A), push the connector (B) inward.
    G12656393Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the upper oil pan (A).
    G12656394Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Insert the blade of SST (09215-3C000) between the upper oil pan and lower oil pan.
    • Cut off applied sealer and remove the lower oil pan.
  9. Remove the oil pump.

    (Refer to Lubrication System - "OIL PUMP ")

  10. Remove the oil pump (A), together with the upper oil pan (B).
    G12656395Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals