Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Turn the ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the rear-LH wheel, tire, and the inner wheel house.
- Disconnect the canister close valve connector (A).
- Disconnect the vent hose quick-connector (B).
- Disconnect the vapor hose quick-connector (C).
- Remove the canister assembly (E) from the vehicle after removing the mounting nut (D).
- Remove the fuel tank air filter (A) after removing the bolts.
- Remove the vapor tube (B) after removing the bolts (A).