Removal And Installation

WARNING: This page is about a different variant/trim than selected.

Disconnect the battery (-) terminal from the trunk room.
Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "ENGINE ROOM UNDER COVER ")
Drain the engine coolant.
(Refer to Cooling System - "COOLANT ")
Remove the drive belt.
(Refer to Timing System - "DRIVE BELT ")
Remove the water pump pulley (A).
Tightening Torque:

7.8 - 9.8 N.m (0.8 - 1.0 kgf.m, 5.8 - 7.2 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Remove the water pump (A) and gaskets (B).

Courtesy of HYUNDAI MOTOR AMERICA

Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Clean the contact face before assembly.
- Always use a new gasket.
- Always use a new seal bolt (Bolt C)
Tightening Torque
1. (3EA):
  9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
2. (1EA):
  9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
3. (1EA):
  21.6 - 26.5 N.m (2.2 - 2.7 kgf.m, 15.9 - 19.5 lb-ft)
4. (1EA):
  9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
5. (1EA):
  9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
6. (1EA):
  9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 lb-ft)
7. (4EA):
  21.6 - 23.5 N.m (2.2 - 2.4 kgf.m, 15.9 - 17.4 lb-ft)
Courtesy of HYUNDAI MOTOR AMERICA
Install in the reverse order of removal.
Fill the radiator with coolant and check for leaks.
(Refer to Cooling System - "COOLANT ")