Water Inlet Pipe
WARNING: This page is about a different variant/trim than selected.
- Remove the engine and transmission assembly.
(Refer to Engine and Transmission Assembly - "ENGINE AND TRANSMISSION ASSEMBLY ")
- Remove the turbo charger water pipe (A).
- Remove the water inlet pipe (A).
Tightening Torque:
19.6 - 23.5 N.m (2.0 - 2.4 kgf.m, 14.5 - 17.4 Ib-ft)
NOTE:- DO NOT reuse the water pipe o-ring.
- To install, reverse the removal procedure.
- Recheck the coolant level.
(Refer to Cooling System - "COOLANT ")
- Remove the water temperature control assembly.
(Refer to Cooling System - "WATER TEMPERATURE CONTROL ASSEMBLY ")
- Remove the water center pipe (A).
Tightening Torque:
9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 Ib-ft)
NOTE:- Do not reuse the water pipe o-ring.
- To install, reverse the removal procedure.
- Fill the radiator with coolant.
(Refer to Cooling System - "COOLANT ")
- Start engine and check for leaks.