Removal And Installation
WARNING: This page is about a different variant/trim than selected.
- Disconnect the battery (-) terminal from the trunk room.
- Remove the engine cover.
- Remove the engine room cover.
(Refer to Engine and Transaxle Assembly - "ENGINE COVER ")
- Remove the reservoir tank (A) after loosening the mounting bolts from cooling fan and then disconnect the over flow hose (B).
Tightening Torque:
4.9 - 8.3 N.m (0.50 - 0.85 kgf.m, 3.6 - 6.1 lb-ft)
- Install in the reverse order of removal.