Removal And Installation

WARNING: This page is about a different variant/trim than selected.

Disconnect the battery (-) terminal from the trunk room.
Loosen the drain plug and drain the engine coolant.
(Refer to Cooling System - "COOLANT ")
Remove the cooling fan.
(Refer to Cooling System - "COOLING FAN ")
Disconnect the radiator upper hose (A) and lower hose (B).

Courtesy of HYUNDAI MOTOR AMERICA

Courtesy of HYUNDAI MOTOR AMERICA
Remove the ATF cooler pipe bracket (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the Alternator ground wiring protector (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the radiator LH upper mounting bracket and RH upper mounting bracket (B).
Tightening Torque:

7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 Ib-ft)

Courtesy of HYUNDAI MOTOR AMERICA

Courtesy of HYUNDAI MOTOR AMERICA
Remove the fixing bolts (A) between the radiator assembly and the A/C condenser, and then remove the radiator (A) from the vehicle.
Tightening Torque:

4.9 - 7.8 N.m (0.5 - 0.8 kgf.m, 3.6 - 5.8 Ib-ft)

Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse the removal procedure.
Fill the radiator with coolant.
(Refer to Cooling System - "COOLANT ")
Start engine and check for leaks.