[Transmission Mounting Bracket]
WARNING: This page is about a different variant/trim than selected.
- Disconnect the negative battery terminal from the trunk room.
- Remove the engine room under cover.
(Refer to Engine and Transaxle Assembly - "ENGINE ROOM UNDER COVER ")
- Using a jack support the transmission assembly.
- Remove the transmission mounting support bracket (A).
Tightening Torque:
Bolt:
49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 Ib-ft)
[2WD] Nut:
29.4 - 34.3 N.m (3.0 - 3.5 kgf.m, 21.7 - 25.3 Ib-ft)
[AWD] Nut:
49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 Ib-ft)
- Remove the transmission mounting bracket (A).
Tightening Torque:
[2WD] Nut:
29.4 - 34.3 N.m (3.0 - 3.5 kgf.m, 21.7 - 25.3 Ib-ft)
[AWD] Bolt:
49.0 - 63.7 N.m (5.0 - 6.5 kgf.m, 36.2 - 47.0 Ib-ft)
- Install in the reverse order of removal.