Repair Procedures: Removal
WARNING: This page is about a different variant/trim than selected.
- Remove the Nut (B) and Clip (C).
- Remove the Shift Cable (A) assembly from the Transmission.
Tightening Torque:
12.7 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
- Remove the floor console.
(Refer to Body - "FLOOR CONSOLE ")
- Disconnect the shift cable (A) from the shift lever.
- Remove the shift cable assembly (B) by removing the nuts (A).
Tightening Torque:
6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ~ 8.0 lb-ft)
- Pull the rubber plug from the floor and pull out the shift cable assembly.