LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 20 (Engine Control System - 3.3L) >> Variable Force Solenoid (VFS) >> Repair Procedures >> Removal >> Variable Force Solenoid (Intake) >> [Bank 2]

[Bank 2]

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Disconnect the variable force solenoid connector (A).
  3. Remove the installation bolt (B), and then remove the variable force solenoid (VFS) from the engine.
    G12663750Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals