[Bank 1]
WARNING: This page is about a different variant/trim than selected.
WARNING:
- DON'T remove the camshaft position sensor while the engine is running or right after engine is turned off. The part and engine oil is hot and can cause burns.
- Turn the Ignition Switch OFF and disconnect the battery negative (-) cable.
- Remove the Intake Hose.
(Refer to Engine Mechanical System - "INTAKE AND EXHAUST SYSTEM ")
- Disconnect the camshaft position sensor connector (A).
- Remove the installation bolt (B), and then vertically remove the sensor from the cylinder head.
[Bank 1/Intake]
[Bank 1/Exhaust]