LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Ignition System - 3.3L) >> Repair Procedures >> On-Vehicle Inspection >> Inspect Ignition Coil Assembly And Perform Spark Test

Inspect Ignition Coil Assembly And Perform Spark Test

WARNING: This page is about a different variant/trim than selected.
  1. Check for DTCs.
    NOTE:
  2. Check if sparks occur.
    1. Remove the engine cover.
    2. Remove the ignition coils.
    3. Using a spark plug wrench, remove the spark plugs.
    4. Disconnect the injector extension connectors.
    5. Ground the spark plug to the engine.
      G12656522Courtesy of HYUNDAI MOTOR AMERICA
    6. Check if sparks occur at each spark plug while engine is being cranked.
    NOTE:
    • Do not crank the engine for more than 5 seconds.
  3. If sparks do not occur, perform the following test.
    G12656523Courtesy of HYUNDAI MOTOR AMERICA
  4. Using a spark plug wrench, install spark plugs.
  5. Install the ignition coils.
  6. Install the engine cover.
scientia non olet · About LEMON Manuals