Removal And Installation

WARNING: This page is about a different variant/trim than selected.

Disconnect the battery (-) terminal from the trunk room.
Remove the engine cover.
Remove the air cleaner assembly.
(Refer to Intake Exhaust System - "AIR CLEANER ")
Disconnect the fuel hose (A, B) and Brake vacuum hose (C).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the wiring connectors and harness clamps and remove the connector brackets around the surge tank.

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the breather hose (A).

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the vacuum hose (A), styrofoam (B).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the throttle body assembly (A).
Tightening Torque:

7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
Remove the surge tank fixing bracket (A).

Courtesy of HYUNDAI MOTOR AMERICA
Remove the surge tank (A).
Tightening Torque

Step 1: 3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 Ib-ft)

Step 2: 9.8 - 11.8 N.m (1.0 - 1.2 kgf.m, 7.2 - 8.7 Ib-ft)

Courtesy of HYUNDAI MOTOR AMERICA
NOTE:
- Tighten the surge tank bolts in two or three steps.
To install, reverse the removal procedure.