RH Cylinder Head Cover
WARNING: This page is about a different variant/trim than selected.
- Disconnect the Battery (-) Terminal from the Trunk Room.
- Remove the Surge Tank.
(Refer to Intake and Exhaust System - "SURGE TANK ")
- Remove the RH Ignition Coil and Wiring.
(Refer to Engine Electrical System - "IGNITION COIL ")
- Remove the RH exhaust CMP sensor connector (A).
- Remove the RH cylinder head cover.
- Remove the RH exhaust CVVT oil control valve (OCV) cap (A).
- Remove the RH cylinder head cover (B).
NOTE:- Cover the cylinder head with a piece of clean cloth or vinyl cover to prevent foreign materials from entering the cylinder head.