LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 16 (Cylinder Head Assembly - 3.3L) >> Cylinder Head Cover >> Repair Procedures >> Removal >> LH Cylinder Head Cover

LH Cylinder Head Cover

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect the battery (-) terminal from the trunk room.
  2. Remove the surge tank.

    (Refer to Intake and Exhaust System - "SURGE TANK ")

  3. Remove the intake manifold.

    (Refer to Intake and Exhaust System - "INTAKE MANIFOLD ")

  4. Remove the high-pressure fuel pipe.

    (Refer to Fuel system - "DELIVERY PIPE ")

  5. Remove the LH ignition coil and wiring.

    (Refer to Engine Electrical System - "IGNITION COIL ")

  6. Remove the high pressure fuel pump.

    (Refer to Engine Control/Fuel System - "HIGH PRESSURE FUEL PUMP ")

  7. Remove the water outlet pipe.

    (Refer to Cooling System - "WATER TEMPERATURE CONTROL ASSEMBLY ")

  8. Disconnect the PCV hose (A), vacuum hose (B), connector (C).
    G12656143Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the LH Cylinder Head Cover.
    1. Remove the LH exhaust CVVT Oil Control Valve (OCV) cap (A).
    2. Remove the LH Cylinder Head Cover (B).
    G12656144Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Cover the cylinder head with a piece of clean cloth or vinyl cover to prevent foreign materials from entering the cylinder head.
scientia non olet · About LEMON Manuals