LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fuel Delivery System - 3.3L) >> Fuel Tank >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release the Residual Pressure In Fuel Line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  3. Remove the rear seat cushion assembly.

    (Refer to Body - "REAR SEAT ASSEMBLY ")

  4. Remove the service cover (A) of the fuel pump after loosening the screws.
    G12663786Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the fuel feed tube quick - connector (A).
    G12663787Courtesy of HYUNDAI MOTOR AMERICA
  6. Lift the vehicle.
  7. Remove the rear-LH wheel, tire and inner wheel house.
  8. Disconnect the fuel tank extension connector (A), and then remove the wiring harness from the vehicle.
    G12663788Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the Center Muffler Assembly.

    (Refer to Engine Mechanical System - "MUFFLER ")

  10. Remove the Propeller Shaft Assembly.

    (Refer to Driveshaft and Axle - "PROPELLER SHAFT ASSEMBLY ")

  11. Disconnect the fuel filler hose (A).
    G12663789Courtesy of HYUNDAI MOTOR AMERICA
  12. Disconnect the vent tube quick - connect or (A).
    G12663790Courtesy of HYUNDAI MOTOR AMERICA
  13. Support the fuel tank with jack (A).
    G12663791Courtesy of HYUNDAI MOTOR AMERICA
  14. Remove the fuel tank installation nut (B) and then loosen the fuel tank.
    G12663792Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals