LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fuel Delivery System - 3.3L) >> Fuel Pump >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Release the residual pressure in fuel line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Turn the ignition switch OFF and disconnect the negative (-) battery cable.
  3. Remove the rear seat cushion assembly.

    (Refer to Body - "REAR SEAT ASSEMBLY ")

  4. Remove the fuel pump service cover (A) after loosening the screws.
    G12663793Courtesy of HYUNDAI MOTOR AMERICA
  5. Disconnect the fuel pump connector (A) and fuel pressure connector (B).
  6. Disconnect the fuel feed tube quick-connector (C) and the suction hose (D).
  7. Remove the fuel pump plate cover (E) after loosening installation bolts, and then remove the fuel pump.
    G12663794Courtesy of HYUNDAI MOTOR AMERICA
    G12663795Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals