LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fuel Delivery System - 3.3L) >> Fuel Pump >> Repair Procedures >> Inspection >> [Fuel Pump]

[Fuel Pump]

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the fuel pump assembly.

    (Refer to Fuel Delivery System - "FUEL PUMP ")

  3. Connect the fuel pump connector and fuel pressure sensor connector.
  4. Reconnect the negative (-) battery cable.
  5. Turn ignition switch ON or cracking at the no-load state.
  6. Operate the fuel pump.
    CAUTION:
    • Cranking the Max. 3 sec.
  7. Check the normal state of the fuel pump.