[Fuel Pump Three Phase Coil Inspection]
WARNING: This page is about a different variant/trim than selected.
- Turn ignition switch OFF and disconnect the negative (-) battery cable.
- Remove the Fuel Pump Assembly.
(Refer to Fuel Delivery System - "FUEL PUMP ")
- Using an ohmmeter, measure the resistance between terminals U-V, V-W, W-U.
- Check that the resistance is within the specification.
Specification: 0.09 - 0.13Ω
Pin No Description 1 Fuel pump (U) phase control 2 Fuel pump (V) phase control 3 Fuel pump (W) phase control 4 Ground 5 Fuel sender signal 6 Fuel sender ground