LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fuel Delivery System - 3.3L) >> Fuel Pump Motor >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

    CAUTION:
    • When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
  3. Remove the fuel pump.

    (Refer to Fuel Delivery System - "FUEL PUMP ")

  4. Remove the fuel sender connector (A).
  5. Disconnect the pump connector (B).
    G12663811Courtesy of HYUNDAI MOTOR AMERICA
  6. Disconnect the suction hose (A) after releasing the fixing hook.
  7. Remove the fixing clip (B), and then disconnect the fuel feed tube quick-connector (C).
    G12663812Courtesy of HYUNDAI MOTOR AMERICA
    G12663813Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the reservoir-cup (B) after releasing the fixing hooks (A).
    G12663814Courtesy of HYUNDAI MOTOR AMERICA
  9. Remove the dual hose (A).
  10. Disconnect the ground (B).
  11. Remove the fuel pressure regulator (D) after releasing the fixing clips (C).
    G12663815Courtesy of HYUNDAI MOTOR AMERICA
  12. Disconnect the dual hose (A).
  13. Disconnect the fuel pump motor connector (B).
    G12663816Courtesy of HYUNDAI MOTOR AMERICA
  14. Remove the fuel pump motor (B) after releasing the fixing hooks (A).
    G12663817Courtesy of HYUNDAI MOTOR AMERICA
    G12663818Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals