LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fuel Delivery System - 3.3L) >> Fuel Pump Control Module (FPCM) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Remove the trunk rear transverse trim.
  3. Fold the luggage side trim (LH).
  4. Disconnect the Fuel Pump Control Module connector (A).
  5. Remove the mounting nuts (B), and then remove the Fuel Pump Control Module (C) from the vehicle.
    G12663833Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals