LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fuel Delivery System - 3.3L) >> Fuel Pressure Sensor (FPS) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch OFF and disconnect the negative (-) battery cable.
  2. Remove the rear seat cushion.

    (Refer to Body - "REAR SEAT ASSEMBLY ")

  3. Remove the fuel pump service cover (A) after loosening the screws.
    G12663837Courtesy of HYUNDAI MOTOR AMERICA
  4. Disconnect the Fuel Pressure Sensor connector (A).
  5. Remove the Fuel Pressure Sensor fixing pin (B).
  6. Remove the Fuel Pressure Sensor (C) from the fuel pump.
    G12663838Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals