LEMON Manuals: Even more car manuals for everyone
Home >> Genesis >> 2020 >> G80 3.8, AWD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 15 (Fuel Delivery System - 3.3L) >> Fuel Line >> Repair Procedures >> Removal >> [Front Fuel Line]

[Front Fuel Line]

WARNING: This page is about a different variant/trim than selected.
  1. Release the Residual Pressure In Fuel Line.

    (Refer to Fuel Delivery System - "RELEASE RESIDUAL PRESSURE IN FUEL LINE ")

  2. Turn the ignition switch OFF and disconnect the negative (-) battery terminal.
  3. Disconnect the fuel feed tube quick-connector (A).
  4. Disconnect the vapor hose (B) which is connected from the PCSV.
    G12663839Courtesy of HYUNDAI MOTOR AMERICA
    NOTE:
    • Open the clamp cover (B) before disconnecting the quick connector. (If the clip is applied)
      G12663840Courtesy of HYUNDAI MOTOR AMERICA
    CAUTION:
    • When removing the quick-connector with the clip removing tool (A), be careful not to damage the plastic clip (B).
    • If the clip is damaged, the fuel line leak can occur due to poor connection.
      G12663841Courtesy of HYUNDAI MOTOR AMERICA
  5. Lift the vehicle.
  6. Remove the front-left wheel & tire and wheel house cover.
  7. Remove the front-left side under cover (A).
    G12663842Courtesy of HYUNDAI MOTOR AMERICA
  8. Remove the fuel line protector (A) after removing mounting nuts.
    G12663843Courtesy of HYUNDAI MOTOR AMERICA
  9. Disconnect the front vapor and fuel tube line quick-connector (A).
    G12663844Courtesy of HYUNDAI MOTOR AMERICA
  10. Remove the front vapor and fuel feed tube bracket (A).
    G12663845Courtesy of HYUNDAI MOTOR AMERICA
  11. Remove the noise barrier (A) after loosening the mounting bolt and nut.
  12. Remove the front vapor and fuel tube line (B).
    G12663846Courtesy of HYUNDAI MOTOR AMERICA
    G12663847Courtesy of HYUNDAI MOTOR AMERICA
scientia non olet · About LEMON Manuals